It was sunny again today, but the wind was very strong, and it felt cold whenever it blew. The wind also brought the humidity way down, so it may have been a good day for gluing panels in place. On windy days like this, when the humidity drops very low, I have to take extra care of the puzzle boxes whose panels I’ve already glued in place, as well as the ones that are nearly finished. The panels can warp, and the mechanisms can become loose.
Today I was ready to glue the sliding key panels onto the 4-sun puzzle boxes, so I glued the panels on one side. The dry air was good for gluing, but I was worried about leaving the boxes out too long before applying the finish. I worked quickly and put the boxes back in their storage case. It looks like we’ll have similar weather tomorrow, so I plan to glue the panels on the other side.
We rarely get days with humidity this low, so today I glued the sliding key panels on the side with less surface area for gluing. If you compare the two puzzle boxes in the photo, you can see more open space near the bottom of the box on the left. That leaves less wood for the panel to attach to. I find these panels especially tricky to glue on 4-sun puzzle boxes that open in 14 steps or fewer. The panels are fairly large compared with the area I can glue. If dry air or other conditions cause a problem with a sliding key panel, it usually happens on the side shown on the left. That’s why, when I glue the panels on both sides, I pay close attention to when I glue this side. A dry day like today is ideal for it. Choosing the wood also helps keep the panels from warping. Even within a single piece of agathis, I look for sections with straight, even grain and use those for these panels.

